Translate

Saturday, February 15, 2020

3D Printing - Tests



After tests, finally found a decent slicer running on Linux and Mac : Ultimaker Cura, but I found the version 3.6.0 working much much better than the latest one (4.4.1)

Let see some print finally, after changing the bed calibration springs, re-calibrate the printer and cleaning up the printing area.




The Cali Cat
After the re-calibration the first print test was the Cali Cat.
Not bad at all.  There is a little detail to figure out but is not bad at all.

Then I re-printer a piece for the X axis tensioner.



The piece on the right was printer earlier, with the original bed springs and sliced using Slic3R.
The one on the left was printed with the new springs and slice with Ultimaker Cura 3.6.0.
An impressive difference !!!!

No comments:

Post a Comment